Kia Sportage: Air conditioning - System operation - Manual climate control system - Features of your vehicle - Kia Sportage SL Owners ManualKia Sportage: Air conditioning

Third generation SL (2010Ц2016) / Kia Sportage SL Owners Manual / Features of your vehicle / Manual climate control system / System operation / Air conditioning

Kia Air Conditioning Systems are filled with environmentally friendly R-134a refrigerant.

1.Start the engine. Press the air conditioning button.

2.Set the mode to the position.

3.Set the air intake control to the outside air or recirculated air position.

4.Adjust the fan speed control and temperature control to maintain maximum comfort.

Х When maximum cooling is desired, set the temperature control to the extreme left position, set the mode control to the MAX A/C position, then set the fan speed control to the highest speed.

CAUTION - Excessive AC

When using the air conditioning system, monitor the temperature gauge closely while driving up hills or in heavy traffic when outside temperatures are high. Air conditioning system operation may cause engine overheating. Continue to use the blower fan but turn the air conditioning system off if the temperature gauge indicates engine overheating.

Air conditioning system operation tips

Heating
1.Set the mode to the position. 2.Set the air intake control to the outside (fresh) air position. 3.Set the temperature control to the desired position. 4.Set the fan speed control to the desired ...

Climate control air filter
The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air conditioning system. If ...

Other Information:

Fuel gauge
The fuel gauge indicates the approximate amount of fuel remaining in the fuel tank. The fuel tank capacity is given in section 8. The fuel gauge is supplemented by a low fuel warning light, whic ...

Injector: Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within t ...

Categories

Copyright © www.kispmanual.com 2014-2019