Kia Optima Manuals

Kia Sportage: Fuel Pump: Repair procedures - Fuel Delivery System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Fuel Pump: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump: Repair procedures

Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5).

Pin No.
Description
1
 - 
2
Fuel sender signal
3
Fuel sender ground
4
Fuel pump motor (+)
5
Fuel pump motor ground

[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Using an ohmmeter, measure the resistance between terminals 2 and 3 of sender connector (A) at each float level.

Pin No.
Description
1
 - 
2
Fuel sender signal
3
Fuel sender ground
4
Fuel pump motor (+)
5
Fuel pump motor ground

4.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position
Resistance(?)
Capacity (?)
E
198~202
5
Warning lamp
168~172
8.5
 1/2
64~68
29
Sender (F)
6~10
55.1

Removal
1.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
2.
Remove the rear seat (Refer to “Seat” in BD group).
3.
Remove the fuel pump service cover (A).

4.
Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
5.
Disconnect the fuel feed tube quick connector (C) and the vapor tube quick-connector (D).

6.
Remove locking ring (A) by using the special service tool (B) [No.:09310-2S200].

Fuel pump locking ring loosening torque: Min. 68.65 M.m (Min. 7 kgf.m, Min. 50.6 lb-ft)
7.
Remove the fuel pump from the fuel tank.

Installation
1.
Installation is reverse of removal.
   
Be careful of fuel pump direction when installing (Refer to the groove in the fuel tank).
Fuel Tank: Repair procedures
Removal 1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). 2. Remove the rear seat cushion (R ...

Filler-Neck Assembly: Repair procedures
Removal 1. Remove the rear-LH wheel, tire, and the inner wheel house. 2. Disconnect the fuel filler hose (A) and the ventilation hose (B). 3. Open the fuel filler door and unfasten the fil ...

Other Information:

Turbo Charger: Components and Components Location
Components 1. Turbine housing2. Turbine inlet3. Turbine outlet4. Compressor housing5. Compressor inlet6. Compressor outlet7. Center housing8. EWGA (Electric Waste Gate Actuator)9. Actuator rod ...

Repair procedures
Adjustment TCM Learning When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed. In the following case, TCM learning is required. ...

Categories

Copyright www.kispmanual.com 2014-2026