Inspection |
1. |
Disconnect the negative battery terminal. |
2. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
3. |
Disconnect the switch connector (16 pins) from wiring harness. |
4. |
Check for continuity between the terminals. If needed, replace the switch. |
Removal |
1. |
Disconnect the negative battery terminal. |
2. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
3. |
Remove the screws from power window switch (A) and connectors (B). |
4. |
Remove the driver power window switch (A) from front door trim.
|
Installation |
1. |
Install the power window switch and connectors. |
2. |
Install the front door trim. |
Repair procedures
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.
2.
Check for continuity between the terminals.
3.
If continu ...
Side Impact Sensor (SIS): Components and Components Location
Components
...