Kia Sportage: RCV Control Solenoid Valve: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / RCV Control Solenoid Valve: Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the RCV control solenoid valve connector.

3.	Measure resistance between the valve terminals 1 and 2.

Check that the resistance is within the specification.

Specification: Refer to â€œSpecificationâ€

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the RCV control solenoid valve after disconnect the connector (A), bolt (B) and RCV hose (C).

Installation

â€¢	Do not apply oil when hose assembled.

â€¢	The hose should be inserted perfectly to nipple.

Installation is the reverse order of removal.

RCV Control Solenoid Valve installatio bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

RCV Control Solenoid Valve: Schematic Diagrams

Circuit Diagram ...

Canister Close Valve (CCV): Description and Operation

Description Canister Close Valve (CCV) is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosphere when leakage dete ...

Other Information:

Troubleshooting
Troubleshooting SymptomPossible causeRemedySpeedometer does not operateCluster fuse (10A) blownCheck for short and replace fuseSpeedometer faultyCheck speedometerCAN line faultyCheck the EMSWirin ...

Seat belt restraint system
For maximum restraint system protection, the seat belts must always be used whenever the vehicle is moving. A properly positioned shoulder belt should be positioned midway over your shoulder ...

Kia Sportage: RCV Control Solenoid Valve: Repair procedures

RCV Control Solenoid Valve: Schematic Diagrams

Canister Close Valve (CCV): Description and Operation

Other Information:

Categories