Kia Sportage: Rear Glass Defogger Switch: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Rear Glass Defogger / Rear Glass Defogger Switch: Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the center fascia panel.
(Refer to BE - "Audio") |
| 3. |
Remove the heater and A/C controller (A) after disconnecting the connector (B).
|
| Installation |
| 1. |
Install the heater and A/C controller. |
| 2. |
Install the center fascia panel. |
| Inspection |
| 1. |
The rear glass defogger switch inputs can be checked using the GDS. |
| 2. |
To check the input value of rear glass defogger switch, select option "BCM". |
| 3. |
Select option "Current Data".
|
| 4. |
To check the input value of rear glass defogger switch in force mode, select option.
|
Rear Glass Defogger Printed Heater: Repair procedures
Inspection
Wrap tin foil around the end of the voltmeter test lead to
prevent damaging the heater line. Apply finger pressure on the tin foil,
moving the tin foil a ...
Other Information:
Manual transaxle operation
The manual transaxle has 6 forward gears.
This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized
in all forward gears so shifting to either a higher or a lower gea ...
Injector: Troubleshooting
Signal Waveform
The three waveforms below are taken from the #1 and #4
injectors. The top waveform is from the high side (feed side) of the #1
and #4 injectors, while the middle waveform is fro ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026