Kia Sportage: Repair procedures - Restraint - Kia Sportage SL Service & Repair ManualKia Sportage: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Restraint / Repair procedures

Component Replacement After Deployment
   
Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
SRSCM
Deployed airbag(s)
Seat belt pretensioner(s)
Front impact sensors
SRS wiring harnesses
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the side/curtain airbag(s) deployed after a collision, replace the following items.
SRSCM
Deployed airbag(s)
Side impact sensor(s) for the deployed side(s)
SRS wiring harnesses
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.
Description and Operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp c ...

Components and Components Location
Components 1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring4. Seat Belt Pretensioner (BPT)5. Pressure Side Impact Sensor (P-SIS)6. Side Impact Sensor (SIS)7. Side Airbag (SAB)8. Passenger A ...

Other Information:

Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in ...

Evaporator Temperature Sensor: Description and Operation
Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling ...

Categories

Copyright www.kispmanual.com 2014-2025