Inspection |
1. |
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
* Diagnostic procedure refer to DTC code. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the extension cover (A). |
3. |
Remove the shower duct (A). |
4. |
Loosen the screws and then remove the cluster ionizer (A). |
5. |
Installation is the reverse order of removal. |
Instrument Cluster: Schematic Diagrams
Circuit Diagram (1)
Circuit Diagram (2)
CLU1 message signal flow (B > C CAN gateway)
CLU2 message signal flow (B > C CAN gateway)
CLU message 1 signal flow (C > B CAN gateway)
CLU message 3 signa ...
Side Airbag (SAB) Module: Repair procedures
Removal
The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag.
1.
Disconnect the battery negative ...