Kia Sportage: Blower Motor: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Motor: Repair procedures

Inspection

1.	Connect the battery voltage and check the blower motor rotation.

2.	If the blower motor is not operating when voltage is applied, substitute with a known-good blower motor and check for proper operation.

3.	If the problem is corrected, replace the blower motor.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector (A) of the blower motor.

3.	Remove the blower motor (B) after loosening the mounting screws.

4.	Installation is the reverse order of removal.

Blower Unit: Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad and heater blower unit. (Refer to HA group - "Heater Unit") 3. Remove the heater blower unit (A) fro ...

Power Mosfet: Repair procedures

Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification ...

Other Information:

Use approved window washer anti-freeze in system
To keep the water in the window washer system from freezing, add an approved window washer anti-freeze solution in accordance with instructions on the container. Window washer anti-freeze is avail ...

ETC (Electronic Throttle Control) System: Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specific ...

Kia Sportage: Blower Motor: Repair procedures

Blower Unit: Repair procedures

Power Mosfet: Repair procedures

Other Information:

Categories