Kia Sportage: Noise and smoke - How does the air bag system operate - Air bag - advanced supplemental restraint system - Safety features of your vehicle - Kia Sportage SL Owners ManualKia Sportage: Noise and smoke

Third generation SL (2010–2016) / Kia Sportage SL Owners Manual / Safety features of your vehicle / Air bag - advanced supplemental restraint system / How does the air bag system operate / Noise and smoke

When the air bags inflate, they make a loud noise and they leave smoke and powder in the air inside of the vehicle. This is normal and is a result of the ignition of the air bag inflator. After the air bag inflates, you may feel substantial discomfort in breathing due to the contact of your chest with both the seat belt and the air bag, as well as from breathing the smoke and powder. Open your doors and/or windows as soon as possible after impact in order to reduce discomfort and prevent prolonged exposure to the smoke and powder.

Though smoke and powder are nontoxic, it may cause irritation to the skin (eyes, nose and throat, etc). If this is the case, wash and rinse with cold water immediately and consult a doctor if the symptom persists.

WARNING - Hot components

Do not touch the air bag storage area's internal components immediately after airbag inflation. The air bag related parts in the steering wheel, instrument panel and the roof rails above the front and rear doors are very hot. Hot components can result in burn injuries.

How does the air bag system operate
Air bags are activated (able to inflate if necessary) only when the ignition switch is turned to the ON or START position. Air bags inflate instantly in the event of a serious frontal collisio ...

Do not install a child restraint on the front passenger’s seat.
Never place a rear-facing child restraint in the front passenger’s seat. If the air bag deploys, it would impact the rear-facing child restraint, causing serious or fatal injury. In addition, d ...

Other Information:

Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH] ...

3 Point rear center belt
To fasten the rear center belt 1.Extract the tongue plate from the hole on the belt assembly cover and slowly pull the tongue plates out from the retractor. 2.Insert the tongue plate (A) into ...

Categories


Copyright © www.kispmanual.com 2014-2024