Kia Optima Manuals

Kia Sportage: Compression Test - Engine Mechanical System - Kia Sportage SL Service & Repair ManualKia Sportage: Compression Test

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Compression Test

Compression Pressure Inspection
   
If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.
Warm up and stop engine.
Allow the engine to warm up to normal operating temperature.
2.
Disconnect the injector extension connector (A) and ignition coil connectors (B).

3.
Remove ignition coils (A).

4.
Remove spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
5.
Check cylinder compression pressure.
(1)
Insert a compression gauge into the spark plug hole.

(2)
Fully open the throttle.
(3)
While cranking the engine, measure the compression pressure.
   
Always use a fully charged battery to obtain engine speed of 200 rpm or more.
(4)
Repeat steps (1) through (3) for each cylinder.
   
This measurement must be done in as short a time as possible.
Compression pressure :
1078 kPa (11.0 kgf/cm?, 156 psi) / 200 ~ 250 rpm
Minimum pressure :
931 kPa (9.5 kgf/cm?, 135 psi)
Difference between each cylinder :
100kPa (1.0kgf/cm?, 15psi) or less
(5)
If the cylinder compression in 1 or more cylinders is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat steps (1) through (3) for cylinders with low compression.
•
If adding oil helps the compression, it is likely that the piston rings and/or cylinder bore are worn or damaged.
•
If pressure stays low, a valve may be sticking or seating is improper, or there may be leakage past the gasket.
6.
Reinstall spark plugs.
7.
Install ignition coils.
8.
Connect the injector extension connector and ignition coil connectors.
9.
Some DTC''s may exist after the inspection test and may need to be manually cleared with GDS.
Specifications
Specifications DescriptionSpecificationsLimitGeneralTypeIn-line, DOHC?Number of cylinders4?Bore86mm (3.385in.)?Stroke86mm (3.385in.)?Total displacement1998cc (121.92cu.in)?Compression ratio9.5 ± ...

Troubleshooting
Troubleshooting SymptionSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Worn crankshaft bearingsLoose or out of specification engine flywheelReplace the crankshaft and ...

Other Information:

4WD ECU: Repair procedures
Replacement     Prior to replacing the 4WD ECU, check the 4WD ECU''s clutch learing with the GDS tool. (Refer to " Coupling assembly " in 4WD group) 1. Remove the lo ...

Horn
To sound the horn, press the horn symbols on your steering wheel. Check the horn regularly to be sure it operates properly. ✽ NOTICE To sound the horn, press the area indicated by the hor ...

Categories

Copyright www.kispmanual.com 2014-2026