Replacement |
1. |
Remove the driveshaft assembly. (RH side)
(Refer to "Front Driveshaft" in Driveshaft and axle) |
2. |
Remove the dust cover (A). |
3. |
Remove the oil seal (A, B). |
4. |
Install the oil seal with special service tools.
|
5. |
Install the new dust cover (A). |
6. |
Add to transfer fluid.
(Refer to "Transfer Fluid" in Front Wheel Transfer Assembly of this group) |
7. |
Install the drive shaft assembly. (RH side)
(Refer to "Front Driveshaft" in Driveshaft and axle) |
1. |
Remove the transfer assembly from the transaxle assembly.
(Refer to "Front Wheel Transfer Assembly" in this group) |
2. |
Remove the oil seal (A). |
3. |
Install the oil seal with special service tools (09473-3B100).
|
4. |
Add to transfer fluid.
(Refer to "Transfer Fluid" in Front Wheel Transfer Assembly of this group) |
5. |
Install the transfer assembly.
(Refer to "Front Wheel Transfer Assembly" in this group) |
Direct Electro Hydraulic Actuator Coupling: Repair procedures
Inspection
All units are filled up with coupling fluid (ultra-low
viscosity ATF) prior to shipping. Inspection, fill-up, and replacement
of coupling fluid is theref ...
Engine compartment fuse replacement
1.Turn the ignition switch and all other switches off.
2.Remove the fuse panel cover by pressing the tab and pulling the cover up. When
the blade type fuse is disconnected, remove it by using the ...