Kia Sportage: Steering Angle Sensor: Description and Operation
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Brake System / ESC(Electronic Stability Control) System / Steering Angle Sensor: Description and Operation
| Description |
The Steering Angle Sensor (SAS) is installed in MDPS (Motor
Driven Power Steering) and it sends messages to HECU through CAN
communication line.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from the SAS when performing ESC-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe
relay, etc.) of the EPS system are located inside the steering column
& EPS unit assembly and the steering column & EPS unit assembly
must not be disassemble to inspect or replace them. (Refer to “ST
(Steering system) Gr.”)
DBC Switch: Repair procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad side switch assembly.
3.
Check the continuity between the switch terminals as ...
Other Information:
Seat belt warning (for driver’s seat)
As a reminder to the driver, the seat belt warning light will blink for approximately
6 seconds each time you turn the ignition switch ON regardless of belt fastening.
If the driver's seat be ...
Curtain Airbag (CAB) Module: Components and Components Location
Components
...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026