Kia Optima Manuals

Kia Sportage: Front Bumper: Repair procedures - Bumper - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Front Bumper: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Bumper / Front Bumper: Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover (A) mounting clips and bolts.

2.
Remove the under cover (A) mounting clips.

3.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
   
•
When you pull out the front bumper, the front bumper could be damaged by the projection (A).

4.
Disconnect the fog lamp (A), turn signal lamp (B), front sensor (C).
5.
Remove the front bumper.
[LH]

[RH]

6.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.
Front Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [LH]3. Front bumper side bracket [RH] ...

Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH] ...

Other Information:

Operation of the Back up warning system
Operating condition This system will activate when backing up with the ignition switch ON. If the vehicle is moving at a speed over 10 km/h (6 mph), the system may not be activated correctl ...

Voice Recognition
When using the voice recognition feature, only commands listed within the user's manual are supported. Be aware that during the operation of the voice recognition system, pressing any k ...

Categories

Copyright www.kispmanual.com 2014-2026