Kia Sportage: Turn Signal Lamp: Repair procedures - Lighting System - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Turn Signal Lamp: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Turn Signal Lamp: Repair procedures

Removal
Rear Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to BD group - "Rear Bumper")
3.
Disconnect the connector. Remove the rear turn signal lamp (A) after loosening 5 screws.

4.
Replace the bulb (A) of rear turn signal lamp.
? If replacing the bulb only, you could work it without removing the rear bumper.
Door Mirror Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror from the mirror holder.
Be careful not to damage to the clip.
3.
Remove the door mirror turn signal lamp (A) after disassembling screw and connector.

Installation
Rear Turn Signal Lamp
1.
Install the bulb to the rear turn signal lamp assembly.
2.
Install the rear turn signal lamp to the rear bumper.
Door Mirror Turn Signal Lamp
1.
Install the door mirror turn signal lamp to the door mirror.
2.
Install the door mirror.
3.
Connect the battery terminal (-).
Head Lamps: Repair procedures
Removal     Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off.     ...

Room Lamp: Repair procedures
Inspection 1. Remove the room lamp assembly connector then check for continuity between terminals. Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) fro ...

Other Information:

Electric Waste Gate Actuator (EWGA): Components and Components Location
Components 1 . Housing2 . Cover 3. Sealing Cover4 . Motor5. Pinion6 . Shaft Gear7 . PCB Assembly8 . Middle Gear9 . Lever10 . Lever Pin11 . Rod - End12 . Rod ...

Inhibitor Switch: Specifications
Specifications ? Type: Combination of output signals from 4 terminals Power supply (V)12Output typeCombination of output signals Signal Code Table ?PP-RRR-NNN-DDS112V12V00000S2012V12V12V00 ...

Categories

Copyright www.kispmanual.com 2014-2026