Removal |
1. |
Lift up the vehicle.
(Refer to GI group - "Lift and support points") |
2. |
Remove the rear bumper.
(Refer to the BD group - "Rear bumper") |
3. |
Pull out the sensor by opening the sensor holder out. |
4. |
Disconnect the connector from the ultrasonic sensor. |
Installation |
1. |
Install the sensor and connector. |
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back
for low beams.
The high beam indicator will light when the headlight high beams are switched
on.
To prevent the ...
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the wind ...