Kia Optima Manuals

Kia Sportage: Windshield Wiper-Washer Switch: Repair procedures - Windshield Wiper/Washer - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Windshield Wiper-Washer Switch: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing 3 screws.

   
Take care not to damage and scratch the shrouds and its related parts.
Take care not to damage the hook when removing the upper and lower shrouds.
3.
Disconnect the light switch connector (A) and the wiper switch connector (B).

4.
Remove the wiper switch (A) by pushing the lock pin (B).
   
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

5.
Remove the steering wheel.
(Refer to ST group - "Steering column and shaft")
6.
Remove the clock spring.
(Refer to RT group - "Airbag module")
7.
Remove the multifunction switch assembly (A) after loosening screws (2EA).

Installation
1.
Install the multifunction switch after connecting the connector.
2.
Install the clock spring and steering wheel.
3.
Install the steering column upper and lower shrouds.
Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch.

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

Components and Components Location
Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor (Front)6. Washer reservoir7. Wash ...

Front Wiper Motor: Components and Components Location
Component Location 1. Cap2. Nut3. Wiper arm & blade4. Clip5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector ...

Other Information:

Delivery Pipe: Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pre ...

Cruise Control Switch: Repair procedures
Removal and Installation 1. Disconnect the battery (-) terminal. Tightening torque: Without battery sensor : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft) With battery sensor : 4.0 ~ 6.0N ...

Categories

Copyright www.kispmanual.com 2014-2026