Inspection |
1. |
Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. |
2. |
Inspect the voltage value whether it is sufficient to be regular value or not.
|
3. |
If the measured voltage value is not specification, replace the A/C pressure transducer. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Recover the refrigerant with a recovery/charging station. |
3. |
Disconnect the A/C pressure transducer connector (3P) (A).
|
4. |
Installation is the reverse order of removal. |
Rear Wheel Speed Sensor: Repair procedures
Removal
1.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
2.
Remove the luggage side trim the disconnect the r ...
Snow tires
If you equip your car with snow tires, they should be the same size and have
the same load capacity as the original tires. Snow tires should be installed on
all four wheels; otherwise, poor handli ...