Kia Sportage: Description and Operation

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Back View Camera System / Description and Operation

Description

Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.

This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or the Navigation unit while backing-up.

This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can''t see through the camera.

Schematic Diagrams

Circuit Diagram ...

Repair procedures

Removal 1. Remove the tailgate trim in the trunk after removing the screws and clips. (Refer to the BD group - "Tailgate") 2. Remove the tailgate garnish (A) after disconnecting the connector ...

Other Information:

Driver Airbag (DAB) Module and Clock Spring: Description and Operation
Description Driver Airbag (DAB) is installed in the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by deploying the airbag when frontal crash oc ...

Rear Cross Member: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bo ...

Kia Sportage: Description and Operation

Schematic Diagrams

Repair procedures

Other Information:

Categories