Kia Sportage: Front Washer Motor: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor: Repair procedures

Inspection

Front Washer Motor

With the washer motor connected to the reservoir tank, fill the reservoir tank with washer fluid.

Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.

2.	Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively.

3.	Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.

If they are abnormal, replace the washer motor.

No	Description	No	Description
1	Ground	2	Windshield washer (+)

Removal

â€“	When servicing the washer pump, be careful not to damage the washer pump seal.

â€“	Do not operate the washer pump before filling the washer reservoir. Failure to do so could result in premature pump failure.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to the BD group - "Front bumper")

3.	Remove the front washer motor connector (A).

4.	Remove the rear washer motor connector (A).

5.	Remove the washer hose, the front washer motor and the rear washer motor.

6.	Remove the washer reservoir (A) after removing 3 bolts.

Installation

Reassemble the washer reservoir.

Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.

2.	Connect the washer motor connectors and washer hoses.

3.	Install the front and rear washer motor.

Install the front and rear washer nozzle.

Tightening torque (Bolt)

4 ~ 6 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~4.3 lbf.ft)

5.	Install the front bumper cover.

6.	Refill the washer fluid.

Front Wiper Motor: Repair procedures

Removal 1. Remove the windshield wiper arm and blade after removing a nut (B) and wiper cap (A). 2. Remove the windshield wiper arm and blade (A). 3. If necessary, release the wiper blade ...

Rain Sensor: Schematic Diagrams

Circuit Diagram ...

Other Information:

Engine Coolant Temperature Sensor (ECTS): Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECT ...

Transaxle Control Module (TCM): Description and Operation
Description Transaxle Control Module (TCM) is the automatic transmission''s brain. The module receives and processes signals from various sensors and implements a wide range of transmission con ...

Kia Sportage: Front Washer Motor: Repair procedures

Front Wiper Motor: Repair procedures

Rain Sensor: Schematic Diagrams

Other Information:

Categories