Kia Sportage: Front Wheel Speed Sensor: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor: Repair procedures

Removal

Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

2.	Remove the front wheel guard .

3.	Disconnect the front wheel speed sensor connector, then remove the front wheel speed sensor.

4.	Installation is the reverse of removal.

Inspection

Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

In order to protect the wheel speed sensor, when measuring output voltage, a 100 ? resistor must be used as shown.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V ~ 0.84V

V_high : 1.18V ~ 1.68V

Frequency range : 1 ~ 2,500Hz

Front Wheel Speed Sensor: Components and Components Location

Components 1. Front wheel speed sensor connector2. Front wheel speed sensor ...

Rear Wheel Speed Sensor: Components and Components Location

Components 1. Rear wheel speed sensor connector2. Rear wheel speed sensor ...

Other Information:

Heater & A/C Control Unit(Full Automatic): Components and Components Location
Component Connector Pin Function ConnectorPin NOFunctionConnectorPin NOFunctionConnector(A)1BatteryConnector(B)1CAN (LOW)2Tail Lamp (ILL+)2CAN (HIGH)3IG23Intake Actuator (F/B)4DR Temp Actuator ( ...

To decrease the cruising speed
Follow either of these procedures: Push the - SET switch and hold it. Your vehicle will gradually slow down. Release the switch at the speed you want to maintain. Push the - SET switch and ...

Kia Sportage: Front Wheel Speed Sensor: Repair procedures

Front Wheel Speed Sensor: Components and Components Location

Rear Wheel Speed Sensor: Components and Components Location

Other Information:

Categories