Inspection |
1. |
Check the handsfree remote control switch for resistance between No.3 and No.4 terminals in each switch position. [Call + Hang Up]
[Voice]
|
Removal |
1. |
Remove the driver airbag module.
(Refer to the RT group - "Airbag module") |
2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column and shaft") |
3. |
Remove the steering lower bezel (A) after loosening 2 screws and connector (B). |
4. |
Remove the handsfree remote control switch. |
Installation |
1. |
Install the handsfree remote switch to the steering wheel bezel. |
2. |
Install the steering wheel and bezel. |
3. |
Reconnect the handsfree remote control switch connector and airbag connectors.
|
4. |
Install the driver airbag module. |
Auto Light Sensor: Repair procedures
Inspection
In the state of IGN1 ON, when multi function switch module
detects auto light switch on, tail lamp relay output and head lamp low
relay output are controlled according to auto light ...
USING THE USB DEVICE
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connecte ...