The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals.
R : Replace
I : Inspect and, after inspection, clean, adjust, repair or replace if necessary
(1) Transfer case Oil and Rear Axle Oil should be changed anytime they have abeen submerged in water.
SEVERE DRIVING CONDITIONS
A - Repeatedly driving shorts distanse of less than 8 km
(5 miles) in normal temperature or less than 16 km
(10 miles) in freezing temperature
B - Extensive engine idling or low speed driving for long distances
C - Driving on rough, dusty, muddy, unpaved, graveled or salt-spread roads
D - Driving in areas using salt or other corrosive materials or in very cold weather
E - Driving in sandy areas
F - Driving in heavy traffic area over 32°C (90°F)
G - Driving on uphill, downhill, or mountain road
H - Towing a Trailer, or using a camper, or roof rack
I - Driving as a patrol car, taxi, other commercial use or vehicle towing
J - Driving over 170 km/h (106 mph)
K - Frequently driving in stop-and-go conditions
Steering Angle Sensor: Description and Operation
Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor
Driven Power Steering) and it sends messages to HECU through CAN
communication line.
The SAS is used to determine turnin ...
Line Pressure Control Solenoid Valve: Description and Operation
Description
line pressure control solenoid valve is attached to the valve
body. This variable force solenoid valve directly controls the
hydraulic pressure inside the line pressure. ...