Kia Sportage: Specifications

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / General Information / Specifications

Specification

Air Conditioner

Item		Specification
Compressor	Type	DVE16
	Oil type & Capacity	PAG OIL 120Â±10
	Pulley type	6PK-TYPE
	Displacement	160cc/rev
Condenser	Heat rejection	14,000 Â±5% kcal/hr
A/C Pressure transducer	The method to measure the pressure	Voltage= 0.00878835 * Pressure (psig) + 0.5
Expansion valve	Type	Block type
Refrigerant	Type	R-134a
Refrigerant	Capacity [g.(oz)]	550Â±25 (19.4Â±0.88)

Blower Unit

Item		Specification
Fresh and recirculation	Operating method	Actuator
Blower	Type	Sirocco
	Speed step	Auto + 8 speed (Automatic), 1~4speed (Manual)
	Speed control	Power mosfet (Auto), Resistor(manual)
Air filter	Type	Particle filter

Heater And Evaporator Unit

Item		Specification
Heater	Type	Pin & Tube type
	Heating capacity	4,600 - 5% kcal/hr
	Mode operating method	Actuator
	Temperature operating method	Actuator
Evaporator	Temperature control type	Evaporator temperature sensor
Evaporator	A/C ON/OFF [Â°C(Â°F)]	ON : 1.5 Â± 0.5 (34.7 Â± 32.9) OFF: -0.5 Â± 0.5 (32.9 Â± 32.9)

Troubleshooting

Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. ...

Other Information:

Rear Wheel Speed Sensor: Repair procedures
Removal 1. Remove the rear wheel speed sensor mounting bolt (A). Tightening torque: 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) 2. Remove the luggage side trim the disconnect the r ...

Rain Sensor: Repair procedures
Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor inpu ...

Kia Sportage: Specifications

General Information

Troubleshooting

Other Information:

Categories