Kia Optima Manuals

Kia Sportage: Troubleshooting - General Information - Heating,Ventilation, Air Conditioning - Kia Sportage SL Service & Repair ManualKia Sportage: Troubleshooting

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / General Information / Troubleshooting

Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.
After correcting the malfunction, check the complete system to ensure that performance is satisfactory.
Symptom
Suspect Area
No blower operation
1.       Blower fuse
2.       Blower motor
3.       Power mosfet, Blower resistor
4.       Blower speed control switch
5.       Wire harness
No air temperature control
1.       Engine coolant capacity
2.       Heater control assembly
No compressor operation
1.       Refrigerant capacity
2.       A/C Fuse
3.       Magnetic clutch
4.       Compressor
5.       A/C pressure transducer
6.       A/C switch
7.       Evaporator temperature sensor
8.       Wire harness
No cool comes out
1.       Refrigerant capacity
2.       Refrigerant pressure
3.       Drive belt.
4.       Magnetic clutch.
5.       Compressor
6.       A/C pressure transducer
7.       Evaporator temperature sensor.
8.       A/C switch.
9.       Heater control assembly
10.    Wire harness
Insufficient cooling
1.       Refrigerant capacity
2.       Drive belt
3.       Magnetic clutch
4.       Compressor
5.       Condenser
6.       Expansion valve
7.       Evaporator
8.       Refrigerant lines
9.       A/C pressure transducer
10.   Heater control assembly
No engine idle-up when A/C switch ON
1.       Engine ECM
2.       Wire harness
No air inlet control
1.       Heater control assembly, Mode actuator
No mode control
1.       Heater control assembly
2.       Mode actuator
No cooling fan operation
1.       Cooling fan fuse
2.       Fan motor
3.       Engine ECM
4.       Wire harness

Specifications
Specification Air Conditioner ItemSpecificationCompressorTypeDVE16Oil type & CapacityPAG OIL 120±10Pulley type6PK-TYPEDisplacement160cc/revCondenserHeat rejection14,000 ±5% kcal/hrA/C Pres ...

Special Service Tools
Special Service Tools Tool (Number and name)IllustrationUse09977-29000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly. ...

Other Information:

Front Door: Components and Components Location
Components 1. Front door trim2. Front door inside handle cap3. Front door trim seal4. Front door quadrant inner cover5. Front door module6. Front door panel7. Front door belt outside moulding8. ...

Wheel: Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, fi ...

Categories

Copyright www.kispmanual.com 2014-2026