Kia Sportage: Power Seat Control Switch: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Seat Electrical / Power Seat Control Switch: Repair procedures

Inspection

1.	With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the power seat recliner cover. (Refer to the BD group - "Front seat")

3.	Remove the power seat control switch (A).

Installation

1.	Install the power seat control switch after connecting the connector.

2.	Install the recliner cover and front power seat.

Power Seat Motor: Repair procedures

Inspection Power Seat Motor 1. Remove the front seat. (Refer to BD group - "Front seat") 2. Disconnect the connectors for each motor. 3. With the battery connected directly to the motor ...

Seat Heater Switch: Repair procedures

Inspection Driver / Assist seat 1. Disconnect the negative (-) battery terminal. 2. Remove the gear knob. Remove the floor console upper cover (A) using the appropriate tool. (Refer to BD g ...

Other Information:

Tail Gate: Repair procedures
Replacement Tail Gate Trim Replacement â€¢ When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the relate ...

Cylinder Block: Components and Components Location
Components 1. Piston ring2. Snap ring3. Piston4. Connecting rod 5. Connecting rod upper bearing6. Piston pin7. Connecting rod lower bearing8. Connecting rod bearing cap9. Ladder frame10. Oil filt ...

Kia Sportage: Power Seat Control Switch: Repair procedures

Power Seat Motor: Repair procedures

Seat Heater Switch: Repair procedures

Other Information:

Categories