Kia Sportage: Windshield Wiper-Washer Switch: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch: Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

Remove the steering column upper and lower shrouds (A) after removing 3 screws.

Take care not to damage and scratch the shrouds and its related parts.

Take care not to damage the hook when removing the upper and lower shrouds.

3.	Disconnect the light switch connector (A) and the wiper switch connector (B).

Remove the wiper switch (A) by pushing the lock pin (B).

When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

5.	Remove the steering wheel. (Refer to ST group - "Steering column and shaft")

6.	Remove the clock spring. (Refer to RT group - "Airbag module")

7.	Remove the multifunction switch assembly (A) after loosening screws (2EA).

Installation

1.	Install the multifunction switch after connecting the connector.

2.	Install the clock spring and steering wheel.

3.	Install the steering column upper and lower shrouds.

Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch.

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

Components and Components Location

Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor (Front)6. Washer reservoir7. Wash ...

Front Wiper Motor: Components and Components Location

Component Location 1. Cap2. Nut3. Wiper arm & blade4. Clip5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector ...

Other Information:

Front Driveshaft: Components and Components Location
Components 1. Front driveshaft (LH)2. inner shaft3. Front driveshaft (RH) 1. Split pin2. Castle nut3. washer4. BJ assembly5. Clip A6. BJ boot band7. BJ boot8. Dynamic damper band9. Dynamic d ...

PDM Relay Box: Repair procedures
Removal PDM Relay 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console assembly. (Refer to BD group - "Console") 3. Remove the PDM relay box (A) after loosening t ...

Kia Sportage: Windshield Wiper-Washer Switch: Repair procedures

Components and Components Location

Front Wiper Motor: Components and Components Location

Other Information:

Categories