Kia Sportage: License Lamps: Repair procedures - Lighting System - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: License Lamps: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / License Lamps: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lens (A) and license lamp (B) after loosening 2 screws.

Installation
1.
Install the bulb.
2.
Install the license lamp lens.
Front Fog Lamps: Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

High Mounted stop lamp: Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the tailgate trim. (Refer to the BD group - "Tailgate") 3. Remove the spoiler. (Refer to the ...

Other Information:

Transaxle Control Module (TCM): Repair procedures
Inspection TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check point. ...

Manifold Absolute Pressure Sensor (MAPS): Description and Operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog si ...

Categories


Copyright © www.kispmanual.com 2014-2025