Inspection |
1. |
Ignition "OFF". |
2. |
Disconnect evaporator temperature sensor. |
3. |
Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification
|
Replacement |
1. |
Remove the console extension cover (A). |
2. |
Remove the evaporator temperature sensor (A), by pulling it after rotating 90° in a clockwise direction. |
3. |
Installation is the reverse order of removal. |
Turbo Charger: Repair procedures
On-vehicle Inspection
Turbocharger Diagnostic Flow
If any problem related with
turbocharger, such as lack of engine power, poor acceleration, abnormal
engine noise or oil leaks, may occur, c ...
Blower Unit: Components and Components Location
Component Location
Components
1. Intake case (LH)2. Intake case (RH)3. Blower motor4. Intake door5. Intake actuator6. Mofet [Auto type]7. Resistor [Manual type]8. Climate control air filter cove ...