Kia Optima Manuals

Kia Sportage: Oil Cooler: Repair procedures - Lubrication System - Engine Mechanical System - Kia Sportage SL Service & Repair ManualKia Sportage: Oil Cooler: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Lubrication System / Oil Cooler: Repair procedures

Removal
1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining.
2.
Disconnect the oil cooler coolant hoses (A).

3.
Remove the oil filter (A).

4.
Loosen the mounting bolt (A) and remove the oil cooler assembly (B).

Installation
1.
Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B).
Tightening torque:
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

   
Fix position of oil cooler stopper(A) where oil cooler resists on ladder frame stopper (B).

2.
Apply a light coat of engine oil to the oil filter packing surface (A), and then install the oil filter.
Tightening torque:
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)
3.
Connect the oil cooler coolant hoses (B).

4.
Fill the radiator with coolant and check for leaks.
Balance Shaft & Oil Pump: Repair procedures
Removal BSM (Balance Shaft Module) Chain System 1. Remove the timing chain. (Refer to Timing System in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tens ...

Oil Pressure Switch: Repair procedures
Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. Check the continuity between the terminal ...

Other Information:

Automatic Transaxle: Components and Components Location
Components Location 1. Converter housing2. Automatic transaxle case3. Rear cover4. Valve body cover5. Manual control lever6. Air breather hose7. Inhibitor switch8. Solenoid valve connector ...

RCV Control Solenoid Valve: Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the RCV control solenoid valve connector. 3. Measure resistance between the valve terminals 1 and 2. 4. Check that the resista ...

Categories

Copyright www.kispmanual.com 2014-2026