Kia Sportage: Accelerator Pedal: Repair procedures - Fuel Delivery System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Accelerator Pedal: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal: Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).

3.
Remove the installation nuts (B), the bolt (C) and then remove the accelerator pedal module.

Installation
1.
Installation is reverse of removal.

Accelerator pedal module installation nut:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Accelerator pedal module installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-Neck Assembly: Repair procedures
Removal 1. Remove the rear-LH wheel, tire, and the inner wheel house. 2. Disconnect the fuel filler hose (A) and the ventilation hose (B). 3. Open the fuel filler door and unfasten the fil ...

Delivery Pipe: Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pre ...

Other Information:

Downhill brake control (DBC)
The Downhill Brake Control (DBC) supports the driver driving down a steep hill without the driver depressing the brake pedal. It slows down the vehicle under 8 km/h (5mph) and lets the driver co ...

Components and Components Location
Components 1. Front seat belt2. Height adjuster3. Rear seat belt4. Rear seat belt [Center]5. Rear seat belt buckle ...

Categories

Copyright © www.kispmanual.com 2014-2026