Inspection |
1. |
Check the damage and operation of the control cable. |
2. |
Check the damage of the boot. |
3. |
Check the damage and corrosion of the bushing. |
4. |
Check the damage or weakening of the spring. |
Removal |
1. |
Remove the center console assembly.
(Refer to "Interior(console)" in BD group.) |
2. |
Take off the clip (A) and then remove the shift cable (B). |
3. |
Remove the shift cable assembly in the vehicle after removing the nuts (B) and the retainer (A).
|
4. |
Remove the air duct (A). |
5. |
Remove the air cleaner assembly.
|
6. |
Remove the battery and battery tray.
(Refer to "Charging system" in EE group.) |
7. |
Remove the shift cable (A).
|
8. |
Remove the shift cable inside of cab. |
Installation |
When installing, set room side shift lever and T/M side lever to "N" position. |
1. |
Install in the reverse order of removal. |
Hill-start assist control (HAC)
A vehicle has the tendency to roll back on a steep hill when it starts to go
after stopping. The Hill-start Assist Control (HAC) prevents the vehicle from rolling
back by applying the brakes autom ...
Fan speed control
The fan speed can be set to the desired speed by operating the fan speed control
switch.
To change the fan speed, press ()
the switch for higher speed, or push ()
the switch for lower speed. ...