Kia Optima Manuals

Kia Sportage: Seat Belt Pretensioner (BPT): Repair procedures - Seat Belt Pretensioner - Restraint - Kia Sportage SL Service & Repair ManualKia Sportage: Seat Belt Pretensioner (BPT): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT): Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
2.
To remove the seat belt anchor pretensioner (C), keep on pushing the lock pins (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

3.
Remove the following parts. (Refer to the Body group- Interior trim)
–
Door scuff trim
–
Center pillar trim
4.
Remove the upper anchor bolt.
5.
Disconnect the seat belt pretensioner connector (A).

6.
Loosen the seat belt pretensioner mounting bolt (B,C) and remove the seat belt pretensioner.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the seat belt pretensioner (BPT) with a bolt.
Tightening torque :
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Connect the seat belt pretensioner (BPT) connector.
5.
Install the upper anchor bolts.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the following parts. . (Refer to the Body group- Interior trim)
–
Center pillar trim
–
Door scuff trim
7.
Insert the seat belt to the anchor pretensioner.
8.
Reconnect the battery negative cable.
9.
After installing the seat belt pretensioner (BPT), confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Seat Belt Pretensioner (BPT): Components and Components Location
Components ...

Anchor Pretensioner: Description and Operation
Description Anchor pretensioner operates as well as belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and it ...

Other Information:

Instrument cluster
1. Tachometer 2. Turn signal indicators 3. Speedometer 4. Engine temperature gauge 5.Warning and indicator lights 6. Fuel gauge 7. Odometer/Tripmeter*/Trip computer* 8. Shift position indicat ...

Temperature Control Actuator: Description and Operation
Description 1. Heater unit includes mode control actuator and temperature control actuator. 2. Temperature control actuator is located at the heater unit. It regulates the temperature by the ...

Categories

Copyright www.kispmanual.com 2014-2026