Kia Sportage: Accelerator Position Sensor (APS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Accelerator Position Sensor (APS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS): Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification”

Removal
Refer to "Accelerator Pedal" in this group.
Installation
Refer to "Accelerator Pedal" in this group.
Accelerator Position Sensor (APS): Schematic Diagrams
Circuit Diagram ...

Fuel Tank Pressure Sensor (FTPS): Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system. It is installed on the fuel tank near the fuel pump assembly. It checks the evaporative s ...

Other Information:

Antenna
Type A, B Your vehicle uses a roof antenna to receive both AM and FM broadcast signals. This antenna is removable. To remove the roof antenna, turn it counterclockwise. To install the roof anten ...

Engine Coolant Temperature Sensor (ECTS): Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECT ...

Categories

Copyright www.kispmanual.com 2014-2026