Kia Sportage: Back up warning system precautions - Back up warning system - Features of your vehicle - Kia Sportage SL Owners ManualKia Sportage: Back up warning system precautions

Third generation SL (2010–2016) / Kia Sportage SL Owners Manual / Features of your vehicle / Back up warning system / Back up warning system precautions

✽ NOTICE

This system can only sense objects within the range and location of the sensors; It can not detect objects in other areas where sensors are not installed. Also, small or slim objects, such as poles or objects located between sensors may not be detected by the sensors.

Always visually check behind the vehicle when backing up. Be sure to inform any drivers of the vehicle that may be unfamiliar with the system regarding the systems capabilities and limitations.

WARNING

Pay close attention when the vehicle is driven close to objects on the road, particularly pedestrians, and especially children. Be aware that some objects may not be detected by the sensors, due to the object’s distance, size or material, all of which can limit the effectiveness of the sensor. Always perform a visual inspection to make sure the vehicle is clear of all obstructions before moving the vehicle in any direction.

Non-operational conditions of Back up warning system
The Back up warning system may not operate properly when: 1.Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2.The sensor is covered with foreign ma ...

Self-diagnosis
If you don’t hear an audible warning sound or if the buzzer sounds intermittently when shifting the gear to the R (Reverse) position, this may indicate a malfunction in the Back up warning syste ...

Other Information:

Balance Shaft & Oil Pump: Repair procedures
Removal BSM (Balance Shaft Module) Chain System 1. Remove the timing chain. (Refer to Timing System in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tens ...

Water pump: Repair procedures
Removal and Installation 1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to drain with speed. 2. Remove the drive belt (A) after turning the drive belt ten ...

Categories

Copyright www.kispmanual.com 2014-2026