Kia Optima Manuals

Kia Sportage: Crankshaft Position Sensor (CKPS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Crankshaft Position Sensor (CKPS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS): Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A).

3.
Remove the protector (A).

4.
Remove the installation bolt (A), and then remove the crankshaft position sensor.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine oil to the O-ring.
   
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Crankshaft position sensor installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector installation bolt (M6): 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector installation bolt (M8): 18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
Crankshaft Position Sensor (CKPS): Schematic Diagrams
Circuit Diagram ...

Camshaft Position Sensor (CMPS): Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Other Information:

Trailer brakes
If your trailer is equipped with a braking system, make sure it conforms to your state’s regulations and that it is properly installed and operating correctly. If your trailer weight exceeds the ...

Seat Belt Pretensioner (BPT): Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. To remove the seat belt anchor pretensioner (C), keep on pushing the lock pi ...

Categories

Copyright www.kispmanual.com 2014-2026