Kia Sportage: Immobilizer Control Unit: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit: Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad") |
| 3. |
Remove the steering column assembly.
(Refer to the ST group - "steering column & shaft") |
| 4. |
Disconnect the connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening a bolt.
[USA]
[Canada]
Disconnect the connector of the SMARTRA unit(A) and then remove the bracket and immobilizer unit.
|
| Installation |
| 1. |
Install the immobilizer control unit after connecting the unit connector. |
| 2. |
Install the steering column assembly. |
| 3. |
Install the crash pad lower panel. |
Repair procedures
Replacement
Problems And Replacement Parts:
ProblemPart setScan tool required?All keys have been lostBlank key (4)YESAntenna coil unit does not workAntenna coil unitNOECM does not workPCM(ECM)YE ...
Antenna Coil: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A).
Take care not to damage and scratch the shroud ...
Other Information:
Balance Shaft & Oil Pump: Repair procedures
Removal
BSM (Balance Shaft Module) Chain System
1.
Remove the timing chain.
(Refer to Timing System in this group)
2.
Install a stopper pin (A) after compressing the balance shaft chain tens ...
Components and Components Location
Component Location
1. Cluster assembly2. Seat belt switch3. Vehicle speed sensor4. Engine coolant temperature sender5. Oil pressure switch6. Brake fluid level warning switch7. Parking brake switc ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026