Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch. [Driver Auto Up/Down] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch. [General] [Power Door Lock] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
3. |
Remove the rear power window switch module. |
4. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[General] |
Heater & A/C Control Unit(Manual): Components and Components Location
Components
Connector Pin Function
ConnectorPin NoFunctionConnectorPin NOFunctionConnector(A)1HighConnector(B)1Tail Lamp (ILL+)2Middle High2Battery3Middle Low3Mode Actuator (VENT)4-4Mode Actuator ...
Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing
fuse/relay name and capacity.
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable to y ...