Replacement |
1. |
Remove the rear wheel & tire.
|
2. |
Remove the sprit pin and castle nut or bolt and then disconnect the rear assist arm (A) from the rear axle.
[2WD]
[4WD] |
3. |
Loosen the bolt & nut and then remove the rear assist arm (A) from the sub frame.
[2WD]
[4WD] |
4. |
Installation is the reverse of removal. |
Inspection |
1. |
Check the bushing for wear and deterioration. |
2. |
Check the rear assist arm for deformation. |
3. |
Check ball joint for damage. |
4. |
Check for the all bolts and nuts. |
Turn signals when towing a trailer
When you tow a trailer, your vehicle has to have a different turn signal flasher
and extra wiring. The green arrows on your instrument panel will flash whenever
you signal a turn or lane change. P ...
CVVT Oil Control Valve (OCV): Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...