Kia Optima Manuals

Kia Sportage: Rear Stabilizer Bar: Repair procedures - Rear Suspension System - Suspension System - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Stabilizer Bar: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar: Repair procedures

Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel & tire (A).
2.
Loosen the nut and then remove the rear stabilizer link (B) with the rear lower arm (A).
Tightening torque :
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

3.
Loosen the mounting bolt and then remove the stabilizer bar (A) with the sub frame.
Tightening torque :
44.1 ~ 53.9N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)

4.
Installation is the reverse of removal.
Inspection
1.
Check the rear stabilizer bar for deformation.
2.
Check the rear stabilizer link ball joint for damage.
Rear Lower Arm: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Rear Assist Arm: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bo ...

Other Information:

Antenna Coil: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A).     Take care not to damage and scratch the shroud ...

Output Speed Sensor: Specifications
Specifications ? Type: Hall effect sensor Operation condition (°C)°F(-40~150) -40~302Air gap (mm)in.(0.25~0.70) 0.0098~0.0276Output voltage (V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...

Categories

Copyright © www.kispmanual.com 2014-2019