Kia Sportage: Rear Washer Switch: Repair procedures - Rear Wiper/Washer - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Washer Switch: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Rear Wiper/Washer / Rear Washer Switch: Repair procedures

Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch.

Rear Wiper Switch

Rear Washer Switch

Rear Wiper Motor: Repair procedures
Inspection Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively. 3. Check that ...

Rear Washer Motor: Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.     Before filling the reservoir tank with water, check the fil ...

Other Information:

Repair procedures
Refrigerant System Service Basics Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the ...

Seat Heater Switch: Repair procedures
Inspection Driver / Assist seat 1. Disconnect the negative (-) battery terminal. 2. Remove the gear knob. Remove the floor console upper cover (A) using the appropriate tool. (Refer to BD g ...

Categories

Copyright www.kispmanual.com 2014-2026