Kia Optima Manuals

Kia Sportage: Seat Heater Switch: Repair procedures - Seat Electrical - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Seat Heater Switch: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Seat Electrical / Seat Heater Switch: Repair procedures

Inspection
Driver / Assist seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the gear knob. Remove the floor console upper cover (A) using the appropriate tool.
(Refer to BD group - "Console")

3.
Remove the floor console tray (A).

   
Take care not to damage the hook when removing the switch.
4.
Disconnect the driver / assist seat heater switch connector.

Driver [Heater]

No
Description
1
IGN 1
2
Ground
3
Driver seat heater (Low)
4
Driver seat heater (High)
5
Indicator
6
Illumination (+)
7
Illumination (-)
8
IGN 2
9
 -
10
 -

Driver [Ventilation + Heater]

No
Description
1
Heater IND (High)
2
Battery
3
Illumination (+)
4
Illumination (-)
5
Ventilation IND (High)
6
Ventilation IND (Low)
7
Heater mode
8
Heater IND (Low)
9
 -
10
 -
11
 -
12
Ventilation mode

Assist [Heater]

No
Description
1
IGN 1
2
Ground
3
Assist seat heater (Low)
4
Assist seat heater (High)
5
Indicator
6
Illumination (+)
7
Illumination (-)
8
IGN 2
9
 -
10
 -

5.
Operate each seat heater switch and check that continuity exists between the terminals.
[Heater]

Driver [Ventilation + Heater]

Driver [Ventilation + Heater]

6.
Inspect the switch pin. If needed, replace the seat heater switch (A) after loosening the screws (3EA).

Rear Seat Heater Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the power window switch from the rear door trim.
(Refer to BE group - "Power window switch")

No
Description
1
Indicator (+)
2
Indicator (-)
3
IGN 2
4
Heater (+)
5
Illumination (-)
6
Illumination (+)

3.
Inspect the switch pin. If needed, replace the seat heater switch.

Power Seat Control Switch: Repair procedures
Inspection 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. Remo ...

Seat Heater: Components and Components Location
Component Location ...

Other Information:

SRS components and functions
The SRS consists of the following components: 1.Driver's front air bag module 2.Passenger's front air bag module 3.Side impact air bag modules 4.Curtain air bag modules 5.Retractor pre- ...

Front seat heater
Type A The seat heater is provided to warm the front seats during cold weather. With the ignition switch in the ON position, push either of the switches to warm the driver's seat or the fro ...

Categories

Copyright www.kispmanual.com 2014-2026