Kia Optima Manuals

Kia Sportage: Seat Heater: Repair procedures - Seat Electrical - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Seat Heater: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Seat Electrical / Seat Heater: Repair procedures

Removal
1.
Remove the seat back cover and cushion cover.
(Refer to the BD group - "Front seat")
2.
Remove the driver / assist seat back heater (A) and cushion heater (B).

3.
Remove the cushion cover of rear seat.
(Refer to the BD group - "Rear seat")
4.
Remove the heater (A) of rear seat (LH) and the heater (B) of rear seat (RH).

Installation
1.
Install the driver / assist seat back and cushion heater.
(Refer to the BD group - "Front seat")
2.
Install the heater of rear seat (LH & RH).
(Refer to the BD group - "Rear seat")
Inspection
Driver / Assist Seat
1.
Check for continuity and measure the resistance between terminals as below.

No.
Description
No.
Description
1
Indicator
3
Low
2
Ground
4
High

Standard value
Cushion : 1.39? ± 10% (leather/fabric)
Back : 1.41? ± 10% (leather/fabric)
Set : 2.8? ± 10% (leather/fabric)
2.
Operate seat warmer after connecting the 4P connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value
Cushion : 104 ± 3.6 °F(40 ± 2 °C) (LOW)
107.6 ± 3.6 °F(42 ± 2 °C) (HIGH)
Back : 114.8 ± 3.6 °F(46 ± 2 °C) (LOW),
125.6 ± 3.6 °F(52 ± 2 °C) (HIGH)
Rear Seat
1.
Check for continuity and measure the resistance between terminal 2 and 3.

No
Description
1
Indicator
2
Ground
3
Heater

Standard value
Cushion : 5.29? ± 10% (leather/fabric)
2.
Operate seat warmer after connecting the 4P connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value
Cushion : 104 ± 3.6 °F (40 ± 2 °C)
Seat Heater: Components and Components Location
Component Location ...

Climate Seat: Components and Components Location
Components 1. Ventilation blower2. Ventilation ECU3. Ventilation seat switch4. Blower connector5. Heater connector6. Ventilation ECU connector ...

Other Information:

Engine And Transaxle Assembly: Repair procedures
Removal     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connec ...

Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 1.6 mm (1/16 inch) of tread left on the tire. Replace the tire when ...

Categories

Copyright www.kispmanual.com 2014-2026