Kia Sportage: Hazard Lamp Switch: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Hazard Lamp Switch: Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

Remove the center fascia panel (A).

(Refer to BE group - "Audio unit")

Take care not to damage and scratch the center fascia panel and its related parts.

Apply the protective tapes to the center fascia panel and its related parts.

3.	Disconnect the hazard switch unit connector (A).

4.	If the hazard lamp switch is not as specified, replace it carefully and take care not to damage the hook (A).

Installation

1.	Connect the hazard switch connector.

2.	Install the hazard switch assembly to the center fascia panel.

Inspection

1.	Operate the switch and check for continuity between terminals with an ohmmeter.

Overhead Console Lamp: Repair procedures

Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. No.DescriptionNo.Descrip ...

Rheostat: Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the crash pad side switch assembly (A) af ...

Other Information:

Vehicle certification label
The vehicle certification label attached on the driverâ€™s side center pillar gives the vehicle identification number (VIN). ...

Crankshaft Position Sensor (CKPS): Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine ...

Kia Sportage: Hazard Lamp Switch: Repair procedures

Overhead Console Lamp: Repair procedures

Rheostat: Repair procedures

Other Information:

Categories