Kia Sportage: Blower Unit: Components and Components Location - Blower - Heating,Ventilation, Air Conditioning - Kia Sportage SL Service & Repair ManualKia Sportage: Blower Unit: Components and Components Location

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Unit: Components and Components Location

Component Location

Components

1. Intake case (LH)
2. Intake case (RH)
3. Blower motor
4. Intake door
5. Intake actuator
6. Mofet [Auto type]
7. Resistor [Manual type]
8. Climate control air filter cover
9. Climate control air filter
10. Ionizer
11. Blower case (Upper)
12. Blower case (Lower)
13. Intake seal

Blower
...

Blower Unit: Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad and heater blower unit. (Refer to HA group - "Heater Unit") 3. Remove the heater blower unit (A) fro ...

Other Information:

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Antenna: Repair procedures
Inspection Antenna Cable 1. Remove the antenna jack from the audio unit and antenna. 2. Check for continuity between the center poles of antenna cable. 3. Check for continuity between the ...

Categories


Copyright © www.kispmanual.com 2014-2024