The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected.
1.Start the engine.
2.Set the mode to the desired position. For improving the effectiveness of heating
and cooling;
- Heating:
- Cooling:
3.Set the temperature control to the desired position.
4.Set the air intake control to the outside (fresh) air position.
5.Set the fan speed control to the desired speed.
6.If air conditioning is desired, turn the air conditioning system on.
Press the AUTO button in order to convert to full automatic control of the system.
Luggage Room Lamp: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage room lamp (B) when prying the hole (A) with a flat-up screwdriver.
3.
Remove the luggage room lamp bulb in ca ...
Repair procedures
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger ove ...