Kia Sportage: Blower Unit: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Unit: Repair procedures
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad and heater blower unit.
(Refer to HA group - "Heater Unit") |
| 3. |
Remove the heater blower unit (A) from crash pad.
|
| 4. |
Remove the blower unit (A) from the heater unit (B) after loosening a mounting bolt and screws.
|
| 5. |
Installation is the reverse order of removal. |
Blower Unit: Components and Components Location
Component Location
Components
1. Intake case (LH)2. Intake case (RH)3. Blower motor4. Intake door5. Intake actuator6. Mofet [Auto type]7. Resistor [Manual type]8. Climate control air filter cove ...
Blower Motor: Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor is not operating when voltage is applied,
substitute with a known-good blower motor and ...
Other Information:
Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and
washer switch lever. Turn the switch to the desired position to operate the rear
wiper and washer.
ON - Normal wip ...
Maintenance services
You should exercise the utmost care to prevent damage to your vehicle and injury
to yourself whenever performing any maintenance or inspection procedures.
Should you have any doubts concerning the ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026