Kia Optima Manuals

Kia Sportage: Repair procedures - Ignition System - Engine Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Electrical System / Ignition System / Repair procedures

On-vehicle Inspection
Spark Test
1.
Disconnect the ignition coil connectors (A).

2.
Remove the ignition coils (A).

3.
Using a spark plug socket, remove the spark plug.
4.
Install the spark plug to the ignition coil.
5.
Ground the spark plug to the engine.

6.
Check if spark occurs while engine is being cranked.
   
To prevent fuel being injected from injectors while the engine is being cranked, disconnect the injector connector.
Crank the engine for no more than 5 ~ 10 seconds.
7.
Inspect all the spark plugs.
8.
Using a spark plug socket, install the spark plug.
9.
Install the ignition coil.
10.
Reconnect the ignition coil connector.

Inspect Spark Plug
1.
Disconnect the ignition coil connectors (A).

2.
Remove the ignition coils (A).

3.
Using a spark plug socket, remove the spark plug.
   
Be careful that no contaminates enter through the spark plug holes.
4.
Inspect the electrodes (A) and ceramic insulator (B).

Inspection Of Electrodes
Condition
Dark deposits
White deposits
Description
–
Fuel mixture too rich
–
Low air intake
–
Fuel mixture too lean
–
Advanced ignition timing
–
Insufficient plug tightening torque

5.
Check the electrode gap (A).
Standard
Unleaded : 0.7 ~0.8 mm (0.0276 ~ 0.0315 in.)

Inspect Ignition Coil
1.
Measure the primary coil resistance between terminals (+) and (-).

Standard value: 0.62? ± 10%
Removal and Installation
1.
Disconnect the ignition coil connectors (A).

2.
Remove the ignition coils (A).
Tightening torque :
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)

3.
Installation is the reverse of removal.
Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in ...

Charging System
...

Other Information:

Engine Oil: Repair procedures
Oil And Filter Replacement     • Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, ...

Specifications
Specification ItemDescriptionPower source3VOperating temperature-20°C ~ +60°CRF ModulationFSKRF frequency433.92MHzBattery1EA (CR2032)     An inappropriately disposed b ...

Categories

Copyright www.kispmanual.com 2014-2026