Kia Sportage: Starter Relay: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Engine Electrical System / Starting System / Starter Relay: Repair procedures

Inspection

1.	Remove the fuse box cover.

2.	Remove the starter relay (A).

Using an ohmmeter, check that there is continuity between each terminal.

Terminal	Continuity
30 - 87	NO
85 - 86	YES

4.	Apply 12V to terminal 85 and ground to terminal 86. Check for continuity between terminals 30 and 87.

5.	If there is no continuity, replace the starter relay.

6.	Install the starter relay.

7.	Install the fuse box cover.

Starter: Repair procedures

Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). Tightening torque : 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) 3. Remove the ...

Other Information:

Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in ...

Rail Pressure Sensor (RPS): Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...

Kia Sportage: Starter Relay: Repair procedures

Starter: Repair procedures

Cruise Control System

Other Information:

Categories