Kia Sportage: Camshaft Position Sensor (CMPS): Description and Operation
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS): Description and Operation
| Description |
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and
detects the piston position of each cylinder which the CKPS can''t
detect.
The CMPS is installed on engine head cover and uses a target
wheel installed on the camshaft. The Cam Position sensor is a
hall-effect type sensor. As the target wheel passes the Hall sensor, the
magnetic field changes in the sensor. The sensor then switches a signal
which creates a square wave.
Crankshaft Position Sensor (CKPS): Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Camshaft Position Sensor (CMPS): Troubleshooting
Wave Form
...
Other Information:
Blower Resistor: Repair procedures
Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
measured resistance is not within specification, the blower resistor must be replaced. (After removing the resi ...
If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine will probably be too hot. If this happens,
you should:
1.Pull off the ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © www.kispmanual.com 2014-2024