Kia Sportage: Filler-Neck Assembly: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly: Repair procedures
| Removal |
| 1. |
Remove the rear-LH wheel, tire, and the inner wheel house. |
| 2. |
Disconnect the fuel filler hose (A) and the ventilation hose (B).
|
| 3. |
Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).
|
| 4. |
Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).
|
| Installation |
| 1. |
Installation is reverse of removal.
|
Fuel Pump: Repair procedures
Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecti ...
Accelerator Pedal: Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B), th ...
Other Information:
OFF mode
Press the front blower OFF button to turn off the front air climate control system.
However, you can still operate the mode and air intake buttons as long as the ignition
switch is in the ON pos ...
Tire: Repair procedures
Tire wear
1.
Measure the tread depth of the tires.
Tread depth [limit] : 1.6 mm (0.063 in.)
2.
If the remaining tread (A) depth is less than the limit, replace the tire.
&nbs ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © www.kispmanual.com 2014-2024